Checking and replacing

If testing the starter circuit indicates a fault in the starter motor, Disconnect the battery and remove the motor from the car, Complete with its attached solenoid if it is a pre-engaged type of motor. An inertia type starter motor An inertia-type starter motor is fitted with a Bendix gear on the shaft from the armature. When the starter switch is turned on, the motor rotates rapidly, The shaft turns, and the Bendix gear screws the pinion along a thread Until it engages with the flywheel ring gear on the engine. SEE MORE: How the starting system worksSTARTING SYSTEM: COMPONENTS AND WORKING PRINCIPLES To trace the fault and carry out repairs, You will nearly always have to strip down the motor, Especially if the fault is in the commutator or brush gear. However, the Bendix gear of an inertia-type starter can be repaired Without stripping; removing the motor from the car gives sufficient access. Some faults, such as a badly worn commutator, Are beyond repair and you have to buy a new or exchange motor. However, you can renew worn bearings. Damage to the electrical windings is usually too difficult to deal with at home. An auto-electrician can cure a minor short circuit in the field coils, But anything else calls for fitting a new or exchange motor. A single fault in the motor is probably worth repairing, But if you find more than one fault check the cost of all the spares you need. You may find it cheaper and quicker to replace the motor with an exchange unit. A pre-engaged starter motor A pre-engaged type of starter motor incorporates a solenoid. When the starter switch is turned on, The solenoid activates a lever which first moves the pinion along the Shaft to engage with the flywheel ring gear and only Then operates the switch that starts the motor turning. Removing the starter motor Always disconnect the battery before removing the starter motor, Which is often awkwardly placed low down on the engine. You may have to raise the car on axle stands and work from below. Disconnect the battery (earth terminal first) to avoid an accidental short circuit. Remove the nut that holds in place the heavy lead connecting the starter to the battery. With an inertia-type starter take care not to twist the Terminal post as you are unscrewing the nut. Hold the locknut on the post with an open-ended spanner. Hold the terminal-post but with a spanner While you unscrew the outer nut securing the lead from the battery. With a pre-engaged starter, The heavy lead from the battery is connected to the Solenoid mounted on the starter body. Take careful note of the other leads to the solenoid, Before you disconnect them. Remove the two or three bolts holding the motor to the engine backplate. Unscrew the bolts that hold the starter to the engine backplate Lift out the motor, watching for any spacer shims. Collect them and make a note of their Order so that you can refit them correctly. Reverse the removal procedure to refit the motor. Also, read - How to test a car battery Testing a motor for short circuits Use a test lamp fitted with crocodile clips to make these tests. You will have to remove the endplates from the motor. The field coils are insulated from the motor casing by wrappings. A break in the wrappings can cause a short circuit. If the field-coil test below indicates a break, and the break is only a minor one, An auto electrician may be able to repair it. If the armature test below shows a short circuit, Fit a new or exchange motor. If there are little splashes of solder on the motor, Or any other sign that it has overheated, fit a replacement motor. To check the armature, Connect a test lead between the shaft and a battery terminal. Connect a test lamp lead to the secondary battery terminal and Touch its other end to each commutator segment. If the light of the lamp, there is a short circuit.

Tag: Checking and replacing

Checking and replacing the starter motor