how to recharge an ac system

How to flush the AC system after a compressor failure? Well, there are a few ways to do that. But is there any necessity to do that; When will you replace the failed compressor anyway? We are going to discuss the importance of flushing the system and how to do that. Why Do You Need to Flush the Air Conditioning Unit? A compressor failure in your car’s AC system means you have to install a new one. But flushing the system is requisite before the installation. Solid substances can form in the refrigerant circuit over time, Causing damage to several components. Also, a compressor can send tiny metal, Fragments into the system at the time of failure. These fragments are likely to block the system’s small passages, Which will remain even after changing the compressor? These metal shards can also harm the new compressor. For these reasons, you should always flush the AC unit to remove the metal particles; And other solids whenever changing the failed compressor. How to Flush the AC System after Compressor Failure? You have to flush the condenser of the AC system before replacing the compressor. However, Most automakers including Toyota recommends the replacement of the condenser and Hoses instead of flushing in case of contamination. Two auto manufacturers that recommend condenser flushing are GM and Ford. GM suggests the use of only R-134a for the process. They also want you to do it in a recharging machine to reduce refrigerant loss. On the other hand, Ford approves of using, VSL338 terpene-based solvent for the flushing. Here are several methods of how to flush the AC system After the compressor failure. Remember that you have to flush nothing else; But the condenser, hoses, and evaporator. Also, read - CAR AIR CONDITIONING /AC/ SYSTEM: FUNCTION, COMPONENTS, AND WORKING PRINCIPLE Use AC flushing equipment. There are plenty of flush kits for performing open-loop flushing process. The flusher includes a tank, catch pan, hose, and adapters. Using such a kit is one of the easiest ways to flush the AC system and The whole process takes just about 15 minutes. Use a solvent that does not destroy or harm the inner components. After the cleaning is done, leave those components in the open air for drying correctly. If you want a deep cleaning and reduce the flushing time, Purchase a power flushing kit. It dislodges the hardened particles and completes the cleaning quickly. However, such a machine is expensive, costing around $2,000 to $3,000. Using a kit makes the task easier Use flushing liquid. Instead of using a cleaning solvent, You can also use a flushing liquid (like a chemical- or water-based fluid). This process works better R1234yf air-conditioning systems and For the systems being converted to R134a from R12. You must use nitrogen to dry the components after finishing the cleaning. Blow out each part and pipe one by one with nitrogen. These are the ways how to flush the AC system after a compressor failure. Flushing is done to remove not only substantial buildups from the AC unit; But also dirty liquid and lubricating oil residue. Read More: How Does A Turbofan Engine Work?5 Causes of an Alternator Not Charging

Tag: how to recharge an ac system

How To Flush AC System After Compressor Failure?

How Much PAG Oil To Add To AC System

CAR AIR CONDITIONING /AC/ SYSTEM: FUNCTION, COMPONENTS, AND WORKING PRINCIPLE