Advertisement
Categories: AutomotiveTechnology

EXPLAINING THE MEANING OF GRADE WRITTEN ON BOLT HEAD

Advertisement
Advertisement

A fastener is a device that mechanically joins two or more objects together. In general, fasteners are used to create non-permanent joints. 

That is joints that can be removed or dismantled without damaging the joining components.

Before starting we need to clear some basic mechanical engineering concepts.

Proof Load:

It is defined as the maximum tensile force that can be applied to a bolt that will not result in plastic deformation.

In other words, the material must remain in its elastic region when loaded up to its proof load.

Yield Strength:

Maximum load at which a material exhibits a specific permanent deformation or plastic deformation.

Tensile Strength:

Tensile strength is a measurement of the force required to pull something such as rope, wire, or a structural beam to the point where it breaks.

The tensile strength of a material is the maximum amount of tensile stress that it can take before failure.

In simple words “ digit written on bolt head is indicate its grade”

Now let’s explore all thing deeply.

What Does a Grade Mean?

The grade of your industrial fasteners not only determines how much stress they can stand but also why the type of tool must be used to tighten them.

For a grade 8.8

You must use the part-turn method of tightening with a torque wrench; 

This is where the fold is fit snug tight with your fingers and then advanced up to three turns, depending on length and size. 

Indicating washers may also be used in the part-turn method, and added security of the joint can be accomplished by using other fasteners and fixings, such as spring washers, wired heads, nuts, and split pins. 

What’s the difference between 10.9 and 8.8 bolts?

The first digit relates to the ultimate strength of the material, while the second is the ratio of yield stress to ultimate strength.

Thus grade 10.9 bolts have an ultimate material tensile strength of 1000N/mm2 and the yield (or proof) stress is 90% of the ultimate strength.

Similarly, grade 8.8 bolts have an ultimate strength of 800 N/mm2 and a ratio of yield/proof stress to the ultimate strength of 80%. 



READ: Complete Guide: Fastener Type Chart


READ: Rivets – Types, Failures Of Riveted Joint, Terms Used In Riveting


Visit Forum

Visit Our Friendly Website

Advertisement

View Comments

Share
Published by
The Engineer

Recent Posts

TECHNICAL TERMS OF TOOLS AND CUTTERS EXPLAINED: TECHNICAL BASICS

1. BLOWPIPE Gas welding torch in which oxygen and acetylene are mixed and ejected from… Read More

Why are air bubbles dangerous in a hydraulic brake system?

One of the most necessary conditions for a hydraulic system to function properly is that… Read More

THE REASON: WHY TIRES ARE BLACK?

Note : Tyre vs. Tire. For British motorists, the rubber wheel-covering is called a tyre… Read More

Master Cylinder Failure Symptoms Clutch

A clutch master cylinder is a component found on vehicles equipped with a manual transmission… Read More

Check Out Why do Tools Have DROP FORGED Stamped On Them

We see the words "drop forged" stamped on so many tools. It makes us wonder… Read More

Advertisement